Presentation and Wings - Week 7

During this week we spent the entire time solely working on the reflective wings surrounding the outside of the box. During the building, work was also put into creating the final presentation on our design.

The wings were designed in a way in which they are able to be placed directly onto the box, without further attachment. We utilized pieces of cardboard and aluminum foil to create the wings. However, these pieces are only to be used in the prototype. Sturdier and more reflective pieces would be used in the final design. Several pieces of cardboard were cut using box cutters in specific measurements to create a forty five degree angle when placed around the box. Four side panels were made, along with four corner pieces to fill the gaps created when the sides were angled outwards. The wings are held together by a combination of tape on the bottom corners, and string to connect the pieces and hold them at the correct angle of forty five degrees.

The basic outline and skeleton of the presentation were made in order to guide the presentation. The introduction, solutions, and references were


Comments

Post a Comment

Popular posts from this blog

Reflective Array - Week Six

Image
During this week, we created the base of the reflective array for the sterilizer. We decided to use cardboard as the construction material for the array as it is low cost, easy to manipulate, and accessible. The reflective material has yet to be mounted to the cardboard, but the framework has been created. The base of the array consists of 8 pieces: 4 rectangles and 4 triangles. The bottom of which fit around the top of the box. These pieces will be 45 degrees from the ground. The array is broken into two halves that are tied together using string. We are currently working on a method of attaching the pieces to the body of the box so that they can be easily transported. The purpose of this array is to focus the necessary amount of light energy into the sterilizer. It stands at a 45-degree angle to aim the direct light perfectly downward. Although cardboard and tinfoil were used in the prototype, aluminum sheeting would be better because it is more reflective sturdier an...
Read more

Materials - Week Two

This week the group discussed which materials we will use. Our biggest considerations were cost, availability, and practicality. These requirements must be met so that the design is achievable for both a small clinic and because the teams budget is very little. The Frame-  This outer wooden covering can really be made out of any type of lumber accessible. Drexel's Innovation Design Studio will supply all the lumber necessary for the Solar Sterilizer. In third world countries, wood unfinished wood is relatively cheap and not hard to find. Wood is a very appropriate material for the frame because it is sturdy and an insulator and will be safe to touch when the inside is hot. Insulation-  Insulation will help hold all as much of the heat in the oven as possible. Because this is powered solely by the sun it is going to require a lot of insulation to hold heat. If the oven is getting up to 300F the insulation has to be able to withstand that temper...
Read more